User manual MAKITA 2414B-2

[. . . ] ENGLISH Portable Cut-Off MODEL 2414B 006184 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Wheel diameter Hole diameter No load speed (min ) Dimensions (L x W x H) Net weight With under cover With European type safety guard and under cover Safety class -1 2414B 355 mm 25. 4 mm 3, 800 500 mm x 280 mm x 620 mm 18. 7 kg /II · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. · Note: Specifications may differ from country to country. SYMBOLS END201-2 The following show the symbols used for the equipment. [. . . ] This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. 15. 14. 3 ADDITIONAL SAFETY RULES FOR TOOL 1. Also wear hearing protection during extended periods of operation. Use only wheels recommended by the manufacturer which have a maximum operating speed at least as high as "No Load RPM" marked on the tool's nameplate. Use only fiberglass-reinforced cut-off wheels. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Use only flanges specified for this tool. Be careful not to damage the spindle, flanges (especially the installing surface) or bolt, or the wheel itself might break. Keep guards in place and in working order. Keep hands away from rotating parts. ENB066-1 flutter or excessive vibration that might be caused by poor installation or a poorly balanced wheel. Watch out for flying sparks when operating. They can cause injury or ignite combustible materials. Remove material or debris from the area that might be ignited by sparks. Be sure that others are not in the path of the sparks. Keep a proper, charged fire extinguisher closely available. If the wheel stops during the operation, makes an odd noise or begins to vibrate, switch off the tool immediately. Always switch off and wait for the wheel to come to a complete stop before removing, securing workpiece, working vise, changing work position, angle or the wheel itself. Do not touch the workpiece immediately after operation; it is extremely hot and could burn your skin. Store wheels in a dry location only. 3. 4. Make sure the wheel is not contacting the workpiece before the switch is turned on. [. . . ] Reduced cutting efficiency, premature wheel wear, as well as, possible damage to the tool, cut-off wheel or workpiece may result. · Cutting capacity Max. cutting capacity varies depending upon the cutting angle and workpiece shape. Applicable wheel diameter: 355 mm 005271 Workpiece shape Cutting angle 90° 45° 115 mm 115 mm 120 mm 106 mm 115 mm × 142 mm 102 mm × 197 mm 70 mm × 240 mm 115 mm × 102 mm 139 mm 100 mm 005272 For tools with the under cover To remove the collected dust from the under cover, place the tool with its side up and pull the under cover open after removing the wing bolt as shown in the figure. Be sure to close and secure the under cover with the wing bolt after the removal of dust. 1 2 1. [. . . ]