User manual MAKITA 4076DW

[. . . ] Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. Turn off all controls before removing the battery. Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present. [. . . ] Improper installation may allow dust to enter the motor, resulting in malfunction of the cleaner. · Always switch off the cleaner after each use to prevent damage to the cleaner and to lengthen the service life of the batteries. This cleaner can be operated in "standard" and "strong" suction. For standard suction, slide the switch forward to the LOW position. For strong suction, slide the switch further to the HIGH position. To stop the cleaner, slide the switch back to the OFF position. · 008910 ASSEMBLY Dust disposal · · Use only the Makita charger DC7021 to charge this cleaner. Use of other type chargers may cause the battery to burst, resulting in personal injury and damage. Charge the cleaner when it is to be used for the first time or it has been left uncharged for a long time. Connect the charging plug to the charging connector, then plug in the charger to the power receptacle. The light in front of the cleaner switch will come on and charging will begin. Charging takes approximately 3 - 5 hours. The light goes out after the charging is complete. Refer to the instruction manual for the charger for more details. CAUTION: Do not operate the cleaner during charging. Always disconnect the charging plug from the cleaner after charging. When you charge a new cleaner or a cleaner which has been left uncharged for a long time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the cleaner fully after discharging it completely a couple of times. Maximum charging time may be 9 hours depending on room temperature. · CAUTION: Empty the cleaner before it becomes too full, or the suction force weakens. Be sure to empty out the dust inside the cleaner itself. Failure to do so may cause the sponge filter to be clogged or the motor to be damaged. Never throw away the dust stopper because it should be used whenever either the dust bag or the dust pack is used. [. . . ] An insufficiently dried sponge filter may shorten the service life of the motor. · 008903 3. Disposing cleaner A Ni-Cd battery is built into this cleaner. Always remove it before disposing of the cleaner. 4. Disconnect the three lead wires from the battery by pressing the connector on the part 1 in the direction of arrow shown in the figure and pulling them. Then withdraw the battery unit completely. [. . . ]