User manual MAKITA 4107RH

[. . . ] ENGLISH Cutter MODEL 4107RH 005164 INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Wheel diameter Max. cutting capacities No load speed (min ) Overall length Net weight Safety Class -1 4107RH 180 mm 60 mm 5, 000 370 mm 7. 2 kg Class I · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. · Note: Specifications may differ from country to country. [. . . ] The use of any accessory or attachment, other than those recommended in this instruction manual or the catalog, may present a risk of personal injury. Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. 3. 10. 11. 12. 13. 3 ADDITIONAL SAFETY RULES 1. This tool is equipped with a portable residual current device. Do not connect the tool to a power supply without using the PRCD (Portable Residual Current Device). In case of damage of the cord, it has to be replaced by the manufacturer's service organization. For additional protection against electric shock, be sure to WEAR RUBBER GLOVES AND RUBBER BOOTS during operation. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Use only flanges specified for this tool. Be careful not to damage the spindle, flanges (especially the installing surface) or bolt. Damage to these parts could result in wheel breakage. When using the water feed, be careful not to let water get into the motor. If water runs into the motor, an electric shock hazard may result. Keep hands away from rotating parts. ENB052-2 Make sure the wheel is not contacting the workpiece before the switch is turned on. 2. 10. Wait until the wheel attains full speed before cutting. Stop operation immediately if you notice anything abnormal. Never attempt to cut with the tool held upside down in a vise. This can lead to serious accidents, because it is extremely dangerous. (Fig. Before setting the tool down after completing a cut, be sure that the wheel has come to a complete stop. [. . . ] Then turn the tool on and wait until the wheel attains full speed. Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the cutting is completed. Keep your cutting line straight and your speed of advance uniform. CAUTION: THIS TOOL SHOULD ONLY BE USED ON HORIZONTAL SURFACES. [. . . ]