User manual MAKITA 4604D

[. . . ] Symbols The following show the symbols used for the machine. Be sure that you understand their meaning before use. W e r t y u i o p a s Waist belt Pocket lid Controller connector Waist belt pocket Suspenders Holster Arm band Connection cord Female plug Switch trigger Lock-off lever d f g h j k l ; z x c Upper shear blade Lower shear blade Branch Hex wrench Blade cover Socket wrench Blade holder Magnet Brush Machine oil Diamond file Due to our continuing program of research and development, the specifications herein are subject to change without notice. Note: Specifications may differ from country to country. [. . . ] 5 & 6) After installing the controller on the battery, put the battery with the controller into your waist belt pocket so that the controller connector will point toward your hand with which you operate the shears. Then cover the battery with the pocket lid to keep them from accidentally falling out of your pocket during operation. Charge the battery 4600 with the Makita charger DC4600 before use. Plug the charger into the power receptacle and connect the charging plug into the charging connector on the battery. When the charging light goes out after about one hour, the charging will be completed. If the charging light goes out within one minute after pressing the start button, the battery is dead. After charging, disconnect the charging plug from the battery and power receptacle. cAUTION: · Remove the controller from the battery when charging. Do not keep the start button depressed with tape, etc. The circuit will not function properly and a malfunction of the charger may result. The use of any other chargers may cause damage to the battery. Wear the waist belt and adjust the lengh of suspenders and waist belt so that the battery will be positioned on your back at waist height. It should be positioned on the side where your hand operates the shears. When wearing it, slip the connection cord through the arm band as shown in Fig. Connect the female plug of the connection cord to the shear connector and turn the screw clockwise to secure the female plug in place. NOTE: If you connect or disconnect the connection cord with the controller switched on, the pilot lamp will blink red and green alternately. When this occurs, the shears will not start even if you pull the switch trigger. Switch off the controller and then switch it on again to start the shears. Both the shears and the controller are equipped with an overload protecting mechanism. If the motor is locked for more than three seconds, this mechanism will actuate to stop the shears. also , the pilot lamp on the controller will start to blink red and green alternately. To resume operation, switch off the controller by pressing the lower (O) side of the switch, then switch it on again. [. . . ] Switch off the controller and disconnect the connection cord from the shears and the controller. remove the controller from the battery. Send the shears, connection cord, controller and battery to your dealer or a Makita Service Center to have them inspected and/or repaired. CAUTION: Always be sure that the controller is switched off and the connection cord is disconnected from the shears. [. . . ]