User manual MAKITA 5104S

[. . . ] 19 20 21 22 23 24 25 Front handle Vacuum cleaner Adjusting screw Triangular rule Limit mark Brush holder cap Screwdriver SPECIFICATIONS Model 5104/5104S Blade diameter . /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications may differ from country to country. €¢ Weight according to EPTA-Procedure 01/2003 ENE028-1 Never hold piece being cut in your hands or across your leg. [. . . ] Push the saw forward at a speed so that the blade cuts without slowing. Forcing the saw can cause uneven cuts, loss of accuracy, and possible kickback. Use extra caution when cutting damp wood, pressure treated lumber, or wood containing knots. Adjust speed of cut to maintain smooth advancement of tool without decrease in blade speed. Do not attempt to remove cut material when blade is moving. Wait until blade stops before grasping cut material. Inspect for and remove all nails from lumber before cutting. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. A illustrates the RIGHT way to cut off the end of a board, and Fig. If the workpiece is short or small, clamp it down. Gum and wood pitch hardened on blades slows saw and increases potential for kickback. Keep blade clean by first removing it from tool, then cleaning it with gum and pitch remover, hot water or kerosene. Wear a dust mask and hearing protection when use the tool. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 1) CAUTION: • After adjusting the depth of cut, always tighten the lever securely. Loosen the lever on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tightening the lever. Using proper cut depth helps to reduce potential for dangerous KICKBACKS which can cause personal injury. Before setting the tool down after completing a cut, be sure that the lower guard has closed and the blade has come to a complete stop. Never attempt to saw with the circular saw held upside down in a vise. [. . . ] Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. OPERATION CAUTION: • Be sure to move the tool forward in a straight line gently. Forcing or twisting the tool will result in overheating the motor and dangerous kickback, possibly causing severe injury. [. . . ]