User manual MAKITA 5621RD

[. . . ] 1 To avoid kickback, do support board or panel near the cut. 2 Don't support board or panel away from the cut. 3 A typical illustration of proper hand support and workpiece support. 4 Push button 5 Battery cartridge 6 Charging light 7 Battery charger 8 Loosen (counterclockwise) 9 Hex wrench 10 Shaft lock 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Bolt Outer flange Saw blade Inner flange Hex socket head bolt Cutting depth Lever Bevel scale plate Clamp screw Adjusting screw Base Triangular rule For straight cuts Cutting line 9. [. . . ] Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. 5 illustrates the RIGHT way to cut off the end of a board, and Fig. If the workpiece is short or small, clamp it down. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. Ensure that the diameter, thickness and other characteristics of the saw blade are suitable for the tool. ⷠEnsure that the saw blade is suitable for the spindle speed of the tool. Always switch off the tool before insertion or removal of the battery cartridge. ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the push buttons on both sides of the cartridge. ⷠTo insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Your new battery cartridge is not charged. use the battery charger to charge the battery cartridge. Plug the battery charger into the proper AC voltage source. The charging light will flash in green color. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the battery charger. insert the cartridge fully into the port so that it rests on the charger port floor. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. [. . . ] Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the sawing is completed. To get clean cuts, keep your sawing line straight and your speed of advance uniform. cAUTION: · The riving knife should always be used except when plunging in the middle of the workpiece. ⷠDo not stop the saw blade by lateral pressure on the disc. [. . . ]