User manual MAKITA 5705R

[. . . ] The mains socket used for this device must be protected with a fuse or protective circuit breaker having slow tripping characteristics. Safety hints For your own safety, please refer to the enclosed Safety instructions. Do not use blades which are deformed or cracked. Do not use blades made of high speed steel. [. . . ] Before cutting be sure depth and bevel adjustments are tight. Don't use blades with incorrect size holes. Inspect for and remove all nails from lumber before cutting. Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. Ensure that the diameter, thickness and other characteristics of the saw blade are suitable for the tool. Ensure that the saw blade is suitable for the spindle speed of the tool. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. The following blade can be used with this tool. Do not use saw blades which do not comply with the characteristics specified in these instructions. Do not use saw blades the disc of which is thicker or the set of which is smaller than the thickness of the riving knife. To remove the saw blade, depress the shaft lock fully to prevent shaft rotation, then use the hex wrench to loosen the hex socket head bolt. 1) Now remove the outer flange, raise the safety cover as much as possible, and remove the saw blade. Install the saw blade using the reverse of the removal procedure. Install the inner flange, saw blade, outer flange and hex socket head bolt, in that order. Be sure to secure the hex socket head bolt tightly with the shaft lock fully depressed. Make sure that the blade teeth point forward in the same direction as the tool rotation (the arrow on the blade should point in the same direction as the arrow on the tool). Never depress the shaft lock while the saw is running. Use the socket wrench to loosen the hex head socket bolt for the riving knife adjustment, then raise the safety cover. Move the riving knife up or down over the two protuberances for settings indicated in the illustration, so as to obtain the proper clearance between the riving knife and saw blade. CAUTION: Ensure that the riving knife is adjusted such that: The distance between the riving knife and the toothed rim of the saw blade is not more than 5 mm. The toothed rim does not extend more than 5 mm beyond the lower edge of the riving knife. [. . . ] 1) Ahora quite el collarín exterior, levante la cubierta de seguridad todo lo posible y quite la hoja de sierra. Kontrollera alltid att strömbrytaren fungerar normalt och återgår till ``OFF''-läget när den släpps innan sladden till verktyget kopplas in. Is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. The typical A-weighted noise levels are sound pressure level: 96 dB (A) sound power level: 109 dB (A) ­ Wear ear protection. [. . . ]