User manual MAKITA 6013B

[. . . ] Due to the continuing program of research and development, the specifications herein are subject to change without prior notice. Note: Specifications may differ from country to country. Power supply The machine should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. [. . . ] Hold the machine by the insulated grasping surfaces to prevent electric shock if you drill into a ``live'' wire. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Before plugging in the machine, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Change the direction of rotation only after the machine comes to a complete stop. Changing it before the machine stops may damage the machine. For continuous operation, pull the trigger and then push in the lock button. To stop the machine from the locked position, pull the trigger fully, then release it. To start the machine, simply pull the lower part of the switch for clockwise, the upper part for counterclockwise. CAUTION: Always be sure that the machine is switched off and unplugged before carrying out any work on the machine. Drilling in wood When drilling in wood, best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a centerpunch and hammer at the point to be drilled. place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the machine performance and shorten the service life of the machine. [. . . ] In case of complaint, please send the machine, undismantled, with the enclosed GUARANTEE CERTIFICATE, to your dealer or Makita Service Center. Se till att återföra chucknyckeln till dess ursprungliga position efter att den använts. Vid reklamation skall du sända in hela maskinen, icke isärtagen, tillsammans med det bifogade GARANTIBEVISET (och kvitto/faktura), till din återförsåljare eller till en auktoriserad MAKITA serviceverkstad. [. . . ]