User manual MAKITA 6096DWE

[. . . ] Cordless Driver Drill Equipped with Electric Brake MODEL 6096D 001717 INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Steel Capacities Wood Wood screw No load speed (RPM) Overall length Net weight Battery cartridge 9000 Voltage 9. 6 V Battery Cartridge 9033 Voltage 9. 6 V Input A. C. only 50 Hz - 60 Hz High Low 6096D 10 mm (3/8") 18 mm (11/16") 5. 5 x 55 mm (7/32" x 2-1/8") 0 - 1100/min. [. . . ] The battery must be placed in a well ventilated area during charging. SAVE THESE INSTRUCTIONS 7 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 001718 Installing or removing battery cartridge · · Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, pull out the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Be sure to close the set plate fully before using the tool. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. 1 2 1. Battery cartridge · · Charging 001889 For DC9700A 1. Plug the battery charger into the proper AC voltage source. 1 2. Insert the battery cartridge so that plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the battery charger. The charging light will come on and charging will begin. If the charging light goes out soon, remove the battery cartridge from the charger and let it cool off for more than one minute. Then re-insert it and try to charge it once more. If the charging light goes out within one minute even after repeating this procedure a couple of times, the battery cartridge is dead. When the charging light goes out after about one hour, you may remove the fully charged battery cartridge. CAUTION: Your new battery cartridge is not charged. You will need to charge it before use. 1. Charging light · 8 · If you try to charge a cartridge from a just-operated tool, sometimes the charging light will not come on. If this occurs, let the cartridge cool off for a while. Then reinsert it and try to charge it once more. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. If the charging light flashes alternately in green and red color, charging is not possible. [. . . ] 809 Farmers Branch, TX 75234 (972) 243-1150 12701 Directors Dr. Stafford, TX 77477-3701 (281) 565-8665 3453 IH-35 North, Ste. 101 San Antonio, TX 78219 (210) 228-0676 MASSACHUSETTS 232 Providence Hwy. Westwood, MA 02090 (781) 461-9754 COLORADO 11839 E. [. . . ]