User manual MAKITA 6319D

[. . . ] Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. [. . . ] Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the arrow on the tool body. first , slide the action mode change lever to the position of symbol. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow. The clutch will slip at various torque levels when set at the number 1 to 16. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. nOTE: · The adjusting ring does not lock when the arrow is positioned only halfway between the graduations. Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. cAUTION: · Always check the direction of rotation before operation. ⷠUse the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Install the side grip so that the protrusions on the grip base fit in between the grooves on the barrel. Then tighten the grip by turning clockwise. 8) When not using the driver bit, keep it in the bit holders. [. . . ] Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. EC-DECLARATION OF CONFORMITY Model; 6319D, 6339D, 6349D We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, EN60745, EN55014 in accordance with Council Directives, 2004/108/EC and 98/37/EC. For Model 6319D For European countries only Noise The typical A-weighted noise level determined according to EN60745-2-1: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 85 dB (A). [. . . ]