User manual MAKITA 6412

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Before plugging in the tool, always check to see the switch trigger actuates properly and returns to the "OFF" position when released. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. for 6412 , 6413 To start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. Always check the direction of rotation before operation. â· Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita service center. [. . . ] â· Always secure small workpieces in a vise or similar hold-down device. EC-DECLARATION OF CONFORMITY Model; 6411, 6412, 6413 We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, EN60745, EN55014, EN61000 in accordance with Council Directives, 2004/108/EC and 98/37/EC. For European countries only Noise The typical A-weighted noise level determined according to EN60745-2-1: Sound pressure level (LpA): 82 dB (A) Uncertainty (K): 3 dB (A). [. . . ]