User manual MAKITA 6845

[. . . ] Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. [. . . ] Keep handles dry, clean and free from oil and grease. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to screwdriver safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. cAUTION: Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. Press the dust cover toward the plane bearing and pull out the bit. If the dust cover cannot be moved as far as the plane bearing, try it again after turning the bit slightly. To install the bit, insert it into the socket while turning it slightly. After installing, always make sure that the bit is securely held in place by trying to pull it out. It can be installed on either side of the tool. changing the installation position of hook allows two-way setting of 10 mm (3/8") and 20 mm (13/16") distance from the tool itself. The tool with hook can be hung on the waist belt, a maximum diameter 20 mm (13/16") pipe etc. to remove the hook , just remove the clamping scew. [. . . ] If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or at our option, replace) without charge. This Warranty does not apply where: repairs have been made or attempted by others: repairs are required because of normal wear and tear: the tool has been abused, misused or improperly maintained: alterations have been made to the tool. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]