User manual MAKITA 9563H

[. . . ] 1 2 3 4 5 Shaft lock Slide switch Wheel guard Bearing box Screw 6 7 8 9 Lever Lock nut Depressed center grinding wheel/ Multi-disc Inner flange 10 Lock nut wrench 11 Exhaust vent 12 Inhalation vent Model 9563H Depressed center wheel diameter. M10 Rated speed (n) / No load speed (no) . Due to our continuing program of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. B) The guard must be securely attached to the power tool and positioned for maximum safety, so the least amount of wheel is exposed towards the operator. The guard helps to protect operator from broken wheel fragments and accidental contact with wheel. C) Wheels must be used only for recommended applications. For example: do not grind with the side of cut-off wheel. Abrasive cut-off wheels are intended for peripheral grinding, side forces applied to these wheels may cause them to shatter. D) Always use undamaged wheel flanges that are of correct size and shape for your selected wheel. Proper wheel flanges support the wheel thus reducing the possibility of wheel breakage. Flanges for cutoff wheels may be different from grinding wheel flanges. E) Do not use worn down wheels from larger power tools. Wheel intended for larger power tool is not suitable for the higher speed of a smaller tool and may burst. additional Safety Warnings Specific for Abrasive Cutting-Off Operations: a) Do not "jam" the cut-off wheel or apply excessive pressure. Do not attempt to make an excessive depth of cut. overstressing the wheel increases the loading and susceptibility to twisting or binding of the wheel in the cut and the possibility of kickback or wheel breakage. B) Do not position your body in line with and behind the rotating wheel. When the wheel, at the point of operation, is moving away from your body, the possible kickback may propel the spinning wheel and the power tool directly at you. C) When wheel is binding or when interrupting a cut for any reason, switch off the power tool and hold the power tool motionless until the wheel comes to a complete stop. Never attempt to remove the cut-off wheel from the cut while the wheel is in motion otherwise kickback may occur. Let the wheel reach full speed and carefully reenter the cut. The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece. E) Support panels or any oversized workpiece to minimize the risk of wheel pinching and kickback. Large workpieces tend to sag under their own weight. [. . . ] Before plugging in the tool, always check to see that the switch lever actuates properly and returns to the "OFF" position when released. to start the tool , slide the slide switch toward the "I (ON)" position. For continuous operation, press the front of the slide switch to lock it. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. [. . . ]