User manual MAKITA 9921

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. for public low-voltage distribution systems of between 220 V and 250 V Switching operations of electric apparatus cause voltage fluctuations. The operation of this device under unfavorable mains conditions can have adverse effects to the operation of other equipment. [. . . ] Pull the lever all the way out and install the belt over the rollers, then return the lever to the original position. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to belt sander safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Ventilate your work area adequately when you perform sanding operations. CAUTION: When installing the belt, make sure that the direction of the arrow on the back of the belt corresponds to the one on the tool itself. While the belt is running, use the adjusting knob to center the belt tracking. When attaching the dust bag, push it onto the dust nozzle firmly as far as it will go to prevent it from coming off during operation. For the best results, empty the dust bag when it becomes about half full, tapping it lightly to remove as much dust as possible. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. â· The tool should not be in contact with the workpiece surface when you turn the tools on or off. Otherwise a poor sanding finish or damage of the belt may result. For continuous operation, pull the trigger and then push in the lock button. To stop the tool from the locked position, pull the trigger fully, then release it. Turn the tool on and wait until it attains full speed. then gently place the tool on the workpiece surface. Keep the belt flush with the workpiece at all times and move the tool back and forth. [. . . ] To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, EN60745, EN55014, EN61000 in accordance with Council Directives, 89/336/EEC and 98/37/EC. For European countries only Noise and Vibration The typical A-weighted sound pressure level is 85 dB (A). The noise level under working may exceed 85 dB (A). [. . . ]