User manual MAKITA AH3655

[. . . ] String Press Chip receiver Nut Shear blade Branch catcher Hooks Fit the hooks into groove 31. Grooves Press the hooks on both sides Unlock the hooks Blade cover Screws Under cover Plate Crank Oval hole of shear blade Limit mark Holder cap cover Screwdriver Brush holder cap SPECIFICATIONS Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage 1, 070 mm 5. 36V AH-3656 AH-3665 650 mm 1, 000 - 1, 800 1, 154 mm AH-3666 • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. [. . . ] Switch action CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 3) For your safety, this tool is equipped with a dual switching system. To turn on the tool, press triggers A and B. Release either one of the two pressed triggers to turn off. The sequence of switching is unimportant as the tool only starts when both switches are activated. Battery remaining capacity indicator (only for models with Battery AP-3622) Battery AP-3622 is equipped with the battery remaining capacity indicator. 5) Press the CHECK button to indicate the battery remaining capacity. The indicator lamps will then light for approx. €¢ When only the lowermost indicator lamp (next to the “E”) blinks, or when none of the indicator lamps light, the battery capacity has run out, so the tool does not Speed change (Fig. 4) The strokes per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. In these cases, charge the battery or replace the empty battery with a fully charged one. €¢ When two or more indicator lamps do not light even after charging is complete, the battery has reached the end of its service life. €¢ When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. contact your local Dolmar authorized service center. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. €¢ Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Attach firmly the arm cord hook band placing around your arm and pass the extension cord through the holder. The length of the arm cord hook band is adjustable. NOTE: • Do not pass the extension cord through the band. €¢ Do not force the opening of the holder. failure to do so may cause deflection and damage to it. [. . . ] 31) Insert the top end of slotted bit screwdriver into the notch in the tool and remove the holder cap cover by lifting it up. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. Reinstall the holder cap cover on the tool. 12 Storage The hook hole in the bottom of the blade cover is convenient for hanging the tool from a nail or screw on the wall. [. . . ]