User manual MAKITA AN4531

[. . . ] Model Air pressure Nail length Nail capacity Min. Hose diameter Pneumatic tool oil Dimensions (L X H X W) Net weight AN453 0. Due to our continuing program of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] The nail may be thrown and hit someone, or the tool itself can react dangerously. Do not leave the loaded tool or the air compressor under pressure for a long time out in the sun. Be sure that dust, sand, chips and foreign matter will not enter the tool in the place where you leave it setting. â· Do not point the ejection port at anyone in the vicinity. Keep hands and feet away from the ejection port area. â· When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. Handle the tool carefully, as there is high pressure inside the tool that can be dangerous if a crack is caused by rough handling (dropping or striking). Stop nailing operations immediately if you notice something wrong or out of the ordinary with the tool. (12) Before moving the tool to a new location. â· Do not modify tool without authorization from Makita. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. â· Use only pneumatic tool oil specified in this manual. â· Never connect tool to compressed air line where the maximum allowable pressure of tool cannot be exceeded by 10%. Make sure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure. â· Do not attempt to keep the trigger contact element depressed with tape or wire. â· Always check contact element as instructed in this manual. Nails may be driven accidentally if the safety mechanism is not working correctly. The air compressor must comply with the requirements of EN60335-2-34. select a compressor that has ample pressure and air output to assure cost-efficient operation. The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 40 times per minute at a compression of 0. [. . . ] Pull the trigger first and then place the contact element against the workpiece. 1 method is for intermittent nailing, when you wish to drive a nail carefully and very accurately. Operating the tool without nails shortens the life of the tool and should be avoided. To drive a nail, you may place the contact element against the workpiece and pull the trigger. [. . . ]