User manual MAKITA AN610H

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Air pressure Nail length Nail capacity Min. hose diameter Dimensions (L X H X W) Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] Nails may be driven accidentally if the safety mechanism is not working correctly. ask Makita's Authorized service centers for periodical inspection of the tool. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Read and understand tool labels and manual. Operators and others in work area must wear safety glasses with side shields. Keep fingers away from trigger when not driving fasteners to avoid accidental firing. Use an air hose as large and as short as possible to assure continuous, efficient nailing operation. CAUTION: Low air output of the compressor, or a long or smaller diameter air hose in relation to the nailing frequency may cause a decrease in the driving capability of the tool. The air compressor must comply with the requirements of ANSI B19. The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 50 times per minute at a compression of 250 PSIG (1. 76 MPa , a compressor with an air output over 90 liters/minute is required. Pressure regulators must be used to limit air pressure to the rated pressure of the tool where air supply pressure exceeds the tool's rated pressure. Failure to do so may result in serious injury to tool operator or persons in the vicinity. Adjust the oiler so that one drop of oil will be provided for every 30 nails. When an air set is not used, oil the tool with pneumatic tool oil by placing 2 (two) or 3 (three) drops into the air fitting. This should be done before and after use. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced. This hook can be installed on either side of the tool. When changing the installation position, remove the screw with a screwdriver. Install the hook on another side for installation and then secure it with the screw. [. . . ] Do not nail directly on the concrete or do not use to fasten directly the steel plate to the concrete. Failure to do so may cause concrete fragments to fly off or nails to strike back, causing serious injuries. When nailing, hold the tool so that it stands upright to the driving surface. Slanted nailing may cause concrete fragments to fly off or nails to strike back, causing serious injuries. [. . . ]