User manual MAKITA AT450H

[. . . ] Safety glasses Face shield Contact element Trigger Workpiece Compressor air output per minute Nailing frequency Adjuster Deep Shallow Too deep 12. Exhaust cover Exhaust vent Hex wrench Front guide Contact top Drain cock Air filter Oiler Pneumatic oil Thinner Stove Model Air pressure Applicable staples Staple capacity Min. Due to our continuing program of research and development, the specifications herein are subject to change without notice. Note: Specifications may differ from country to country. [. . . ] Do not leave the loaded tool or the air compressor under pressure for a long time out in the sun. Be sure that dust, sand, chips and foreign matter will not enter the tool in the place where you leave it setting. Do not point the ejection port at anyone in the vicinity. Keep hands and feet away from the ejection port area. When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. accidental firing can be extremely dangerous. Handle the tool carefully, as there is high pressure inside the tool that can be dangerous if a crack is caused by rough handling (dropping or striking). do not attempt to carve or engrave on the tool. Stop stapling operations immediately if you notice something wrong or out of the ordinary with the tool. (12) Before moving the tool to a new location. Do not modify tool without authorization from Makita. ask Makita's Authorized service centers for periodical inspection of the tool. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts. Use only pneumatic tool oil specified in this manual. Never connect tool to compressed air line where the maximum allowable pressure of tool cannot be exceeded by 10%. Make sure that the pressure supplied by the compressed air system does not exceed the maximum allowable pressure of the fastener driving tool. Set the air pressure initially to the lower value of the recommended allowable pressure. Do not attempt to keep the trigger contact element depressed with tape or wire. Always check contact element as instructed in this manual. Staples may be driven accidentally if the safety mechanism is not working correctly. This should be done before and after use. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced. [. . . ] Try on some test samples before actually stapling. This is the mechanism that the tool prevents to be fired without nail. Dry fire prevention automatically sets up when the rest of nails get to last approximately 5 pieces. Be sure that the air socket locks firmly into position when installed onto the air fitting. [. . . ]