User manual MAKITA BDF459

[. . . ] γίες χρήσεως Kullanma kılavuzu NL Snoerloze boor-schroevendraaier Gebruiksaanwijzing DK Akku-slagskruetrækkerbor GR Δραπανοκατσάβιδο μπαταρίας TR Akülü Matkap Tornavida BDF459 1 2 4 3 1 012970 2 012128 5 6 3 012971 4 012972 8 A B 7 5 012973 6 12 012975 9 10 11 7 2 012974 8 012976 13 16 14 15 17 012977 9 10 012798 18 11 012979 12 012978 3 ENGLISH (Original instructions) Explanation of general view 1 2 3 4 5 6 Red indicator Button Battery cartridge Star marking Switch trigger Lamp 7 8 9 10 11 12 Reversing switch lever Speed change lever Adjusting ring Graduation Arrow Sleeve 13 14 15 16 17 18 Groove Hook Screw Bit holder Bit Vent SPECIFICATIONS Model Steel Capacities Wood Wood screw Machine screw No load speed (min–1) Overall length Rated voltage Battery cartridge Net weight • Due to our continuing program of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. € Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE034-1 BDF459 13 mm 38 mm 6 mm x 75 mm M6 0 – 1, 500 0 – 400 179 mm D. Intended use The tool is intended for drilling and screw driving in wood, metal and plastic. [. . . ] € Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. NOTE: • Those temperature-sensitive protection and low-voltage protection is applied only when the tool is used with a battery cartridge with a star mark. 3) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out just after releasing the trigger. installing or removing battery cartridge (Fig. 1) CAUTION: • Always switch off the tool before installing or removing of the battery cartridge. 5 NOTE: • Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 5) CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Fit the bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. [. . . ] However, the tool may back out abruptly if you do not hold it firmly. € Always secure small workpieces in a vise or with a similar hold-down device. € If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. € Do not pull the switch trigger repeatedly when the motor is locked. [. . . ]