User manual MAKITA BFH090F

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Fastening torque No load speed (RPM) Dimensions Net weight Rated voltage Hazardous Location Rating BFH040/BFH040F 0. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. [. . . ] Chargers create sparks which may ignite the dust or fumes. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Be careful not to drop or strike battery. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. ENC005-1 Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, raise the interlock switch and withdraw it from the tool while sliding the button on the front of the cartridge. (Note: Battery cartridge cannot be removed without raising the interlock switch. ) To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Lower the interlock switch after insertion of battery cartridge. [. . . ] This function works to check the proper operation of the LED indicator, front lamp and beeper when a battery cartridge has been inserted into the tool and the interlock switch is lowered. This function works when an abnormal Flickers in red drop of the battery voltage occurs for and green some reason, and the tool stops. This function works if the temperature of the controller or moror increases to a high level and the tool stops. Replace the A series of short battery with fully beeps charged one Remove the battery cartridge A series of short immediately and beeps cool the tool down. [. . . ]