User manual MAKITA BFT042F

[. . . ] 5 700 5 – 12 5 – 12 390 No load speed (min-1) 200 x 65 x 251 mm (with Battery Cartridge BH9020/BH9020A) Dimensions 200 x 65 x 274 mm (with Battery Cartridge BH9033/BH9033A) Net weight Rated voltage 1. 12 V GEB050-2 • Due to our continuing program of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE033-1 CORDLESS SCREWDRIVER SAFETY WARNINGS 1. [. . . ] let a hot battery cartridge cool down before charging it. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge • Always switch off the tool before insertion or removal of the battery cartridge. for Models BFT020F , BFT021F , BFT040F , BFT080F , BFT122F (Fig. 1) • To remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. 4) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. 5) CAUTION: • Always check the direction of rotation before operation. €¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. €¢ When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 6) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The light automatically goes out 10 seconds after the switch trigger is released. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 7) The lamp on the tool shows the following functions. Status of the LED indicator/beeper LED indicator This function works when the tool has reached the preset fastening torque and normal tightening has been completed. [. . . ] If you use the tool beyond the limits, the clutch does not work. And the tool cannot deliver enough fastening torque. NOTE: • The revolution angle means the angle which a screw/ bolt revolves when the tool attains to 100% from 50% of desired torque. In this case, the range of fastening capacity may be inferior to those shown in the above even if a charged battery cartridge is used. [. . . ]