User manual MAKITA BHP446

[. . . ] Blow-out bulb Limit mark Rear cover Recessed part Spring Arm Carbon brush cap Hole SPECIFICATIONS Model Concrete Steel Capacities Wood Wood screw Machine screw No load speed (min-1) Blows per minute Overall length Net weight Rated voltage High (2) Low (1) High (2) Low (1) BHP446 13 mm 13 mm 38 mm 6 mm x 75 mm M6 0 - 1, 500 0 - 400 0 - 22, 500 0 - 6, 000 206 mm 1. 18 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring. [. . . ] The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out 10 -15 seconds after releasing the trigger. NOTE: • Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Before the actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. 5) CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. installing or removing the driver bit or drill bit (Fig. 8) Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. To remove the bit, turn the sleeve counterclockwise. 9) The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. 6) CAUTION: • Always set the speed change lever fully to the correct position. [. . . ] Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts in. CAUTION: • Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. [. . . ]