User manual MAKITA BHP459

[. . . ] €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE079-1 BHP459 13 mm 13 mm 38 mm 6 mm x 75 mm M6 0 – 1, 500 0 – 400 0 – 22, 500 0 – 6, 000 192 mm D. Wear ear protectors with impact drilling. Exposure to noise can cause hearing loss. [. . . ] NOTE: • Those temperature-sensitive protection and low-voltage protection is applied only when the tool is used with a battery cartridge with a star mark. 3) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out just after releasing the trigger. NOTE: • Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 7) The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that the graduations are aligned with the arrow on the tool body. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow. Before the actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. 5) CAUTION: • Always check the direction of rotation before operation. €¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. €¢ When not operating the tool, always set the reversing switch lever to the neutral position. This tool has a reversing switch to change the direction of rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. installing or removing the driver bit or drill bit (Fig. 8) Turn the sleeve counterclockwise to open the chuck jaws. [. . . ] Place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. [. . . ]