User manual MAKITA BHP460WAE

[. . . ] 1 2 3 4 5 6 7 8 9 10 Button Battery cartridge Terminal cover Charging light Grip base Teeth Side grip Loosen Tighten Depth rod 11 12 13 14 15 16 17 18 19 20 Thumb screw Sleeve Bit Bit holder Switch trigger Reversing switch lever A side B side Clockwise Counterclockwise 7. 21 22 23 24 25 26 27 28 29 30 Low speed High speed Speed change lever Action mode changing ring Arrow Adjusting ring Graduations Limit mark Brush holder cap Screwdriver Due to our continuing program of research and development, the specifications herein are subject to change without notice. Note: Specifications may differ from country to country. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] Always keep the vents on charger and battery clean and clear of any obstructions for cooling. The products should be sent for repair or maintenance to a Makita service center, if the yellow warning light keeps flashing. Conditioning charge can extend the life of battery by automatically searching the optimum charging condition for the batteries in every situation. The battery treated in the following conditions repeatedly, will wear out quicker, and yellow warning light may flash. Recharge of battery with its low temperature 3. Recharge under broken cooling system The charging time of such battery is longer than usual. If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its "trickle charge (maintenance charge)" mode and keep the battery cartridge fresh and fully charged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. Never use it for other purposes or for other manufacturer's batteries. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times. If you charge a battery cartridge from a just-operated tool or battery cartridge which has been left in a location exposed to direct sunlight for a long time, the charging light may flash in red color. charging will begin after the battery cartridge is cooled by the cooling fan installed in the charger (DC24SA only). When the temperature on battery is more than approx. 70°C, two charging lights may flash in red color, and when approx. If the charging light flashes alternately in green and red color, charging is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged. Any of the following conditions indicates damage to the charger and/or battery cartridge. ask your Makita Authorized or Factory Service Center to check them. 1) The charging light does not flash (green) when the battery charger is plugged into a power source. [. . . ] Do not use the speed change lever while the tool is running. Select one of the three modes suitable for your work needs by using this ring. For rotation only, turn the ring so that the arrow on the tool body points toward the M mark on the ring. For rotation with hammering, turn the ring so that the arrow points toward the X on the ring. [. . . ]