User manual MAKITA BHR162

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Concrete Capacities Steel Wood No load speed (RPM) Blows per minute Overall length Net weight Rated voltage Standard battery cartridges BHR162 16 mm (5/8") 13 mm (1/2") 24 mm (5/16") 0 - 1, 500/min. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. [. . . ] Ensure the switch is in the off position before inserting battery pack. The screws can come loose easily, causing a breakdown or accident. check tightness of screws carefully before operation. In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Be sure no one is below when using the tool in high locations. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Number of blow Always stop tool operation and charge the battery cartridge when you notice less tool power. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. [. . . ] After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. Dust cup 5 Dust cup 9 Light pressure gives best results. Keep the tool in position and prevent it from slipping away from the hole. [. . . ]