User manual MAKITA BHR180

[. . . ] Red part Button Battery cartridge Switch trigger Lamp Reversing switch lever Rotation with hammering Lock button Action mode changing knob Rotation only Hammering only Grip base 13. Side grip Loosen Tighten Teeth Protrusion Bit shank Bit grease Bit Chuck cover O symbol Depth gauge Dust cup 25. Model Concrete Capacities No load speed (min-1) Blows per minute Overall length Net weight Rated voltage Steel Wood BHR180 18 mm 13 mm 26 mm 0 - 1, 100 0 - 4, 000 352 mm 3. Due to our continuing program of research and development, the specifications herein are subject to change without notice. [. . . ] The lamp keeps on lighting while the switch trigger is being pulled. The light automatically goes out 10 - 15 seconds after the switch trigger is released. nOTE: · Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. ⷠDo not use thinner or gasoline to clean the lamp. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. cAUTION: · Always check the direction of rotation before operation. ⷠUse the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. ⷠWhen not operating the tool, always set the reversing switch lever to the neutral position. Install the side grip so that the teeth on the grip fit in between the protrusions on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position. Coat the bit shank head beforehand with a small amount of bit grease (about 0. This chuck lubrication assures smooth action and longer service life. Clean the bit shank and apply bit grease before installing the bit. Turn the bit and push it in until it engages. Pull the chuck cover down a couple of times. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. [. . . ] This does not affect the drilling precision. Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. [. . . ]