User manual MAKITA BHR261TRDE

[. . . ] ENGLISH (Original instructions) INSTRUCTION MANUAL Cordless Combination Hammer BHR261 BHR261T 009665 IMPORTANT: Read Before Using. 1 ENGLISH (Original instructions) SPECIFICATIONS Model Concrete Capacities No load speed (min-1) Blows per minute Overall length Net weight Rated voltage · Note: Specifications and battery cartridge may differ from country to country. · Weight, with battery cartridge, according to EPTA-Procedure 01/2003 END004-4 BHR261 26 mm 13 mm 32 mm 0 - 1, 200 0 - 4, 800 363 mm 4. 5 kg D. C. 36 V Steel Wood BHR261T 387 mm 4. 7 kg · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Model BHR261T Sound pressure level (LpA) : 92 dB(A) Sound power level (LWA) : 103 dB(A) Uncertainty (K) : 3 dB(A) Wear ear protection ENG900-1 Symbols The following show the symbols used for the equipment. Be sure that you understand their meaning before use. [. . . ] To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. · Lighting up the lamp 1. Lamp 1 009668 Battery protection system The battery cartridge is equipped with the protection system, which automatically cuts off the output power for its long service life. The tool may stop during operation when the tool and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the tool trouble. · When the tool is overloaded: At this time, release the switch trigger and remove causes of overload and then pull the 6 CAUTION: Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The light automatically goes out 10 - 15 seconds after the switch trigger is released. · NOTE: · Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. · Do not use thinner or gasoline to clean the lamp. Such solvents may damage it. Reversing switch action 1. Reversing switch lever Attaching the quick change drill chuck 1. Change cover 3 4 009685 1 2 A B 1 009669 This tool has a reversing switch to change the direction of rotation. [. . . ] CAUTION: Never use "rotation with hammering" when the drill chuck assembly is installed on the tool. The drill chuck assembly may be damaged. Also, the drill chuck will come off when reversing the tool. Pressing excessively on the tool will not speed up the drilling. [. . . ]