User manual MAKITA BJS130

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Keep handles dry, clean and free from oil and grease. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to cement shear safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. It is also recommended that you put on thickly bottomed shoes to prevent injury. Otherwise it can cause damage and trouble on the tool. Be sure no one is below when using the tool in high locations. Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. It can cause serious accident by electric shock. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Always use the correct dust mask/respirator for the material and application you are working with. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. [. . . ] Remove the bearing assmbly (thin one) and screw the bearing assembly for gauge 16 onto the spindle and firmly tighten it with the provided wrench while keeping the spindle still by placing another wrench on the two flat surface on the spindle. Install the optional cutting head by referring to the section titled " Installing cutting head ". CAUTION: Do not confound the bearing assembly provided on the tool (thin one) with that for cutting head for capacity of gauge 16 (Optional Accessory). The bearing assembly provided on the tool is thin while that for cutting head for capacity of gauge 16 (Optional Accessory) is thick. [. . . ]