User manual MAKITA BMR100

[. . . ] When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. Battery compartment (including main battery pack and back up batteries) 12. [. . . ] If the cartridge does not slide in easily, it is not being inserted correctly. This radio equips with three tuning methods ­ Scan tuning, Manual tuning and Memory presets recall. Make sure the rubber bended rod antenna has been well placed for best FM reception. for AM (MW) band , rotate the radio to get best signal. Try to avoid to operate the radio next to computer screen and other equipment which will cause interference to the radio. Press and release Scan button (long press Scan button more than 2 seconds will activate time setting), LCD display will flash Scan symbol and the radio will up search and stop automatically when it finds a radio station, . Press the Scan button again to pick up the found station. note: A stereo symbol will appear on the display , if the station found is a stereo station. Note: The radio will continue to search next available stations if you do not press Scan button again when it finds a radio station. Rotate the Volume control to get required sound level. Stations stored in preset memories can be overwritten by following above procedures. Press the power button to turn on the radio. When the radio alarm is selected, the radio will turn on and play the chosen radio station at the chosen alarm time. The radio alarm will continue for one hour unless turned off by pressing the Power button. pressing the Power button whilst the alarm is activated will cancel the alarm for 24 hours. Note: When the radio is in low battery status, the radio alarm can't be activated. The radio alarm can be set either when radio is on or off. During radio alarm symbol flashing, press button for more than 2 seconds followed by a beep. Display Hour will flash, rotate Tuning Control to select the hour then press button again to confirm hour setting. Follow same procedures of setting hour to set required minute. A single rotary to the Tuning control will change the frequency in the following increment: FM: 50 or 100 kHz AM (MW): 9 or 10 kHz Note: If the radio is in volume control status, press in the tuning/volume control to become Tuning status. Keep on rotating the Tuning control until the required frequency shown on the display. [. . . ] The snooze function can be repeatedly during one hour that the alarms are active. The sleep timer will automatically switched off the radio after a preset time has elapsed. Press and continue to hold down the Power button for more than 2 seconds, followed by a beep tone, the display will cycle through the available sleep times in the order 60-45-30-15-120-90-60. Release the Power button when the required sleep time appears in the display. [. . . ]