User manual MAKITA BO3710

[. . . ] Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. [. . . ] Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Ordinary eye or sun glasses are NOT safety glasses. This tool has not been waterproofed, so do not use water on the workpiece surface. Ventilate your work area adequately when you perform sanding operations. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Use of this tool to sand some products, paints and wood could expose user to dust containing hazardous substances. Be sure that there are no cracks or breakage on the pad before use. To stop the tool from the locked position, pull the switch trigger fully, then release it. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: If the tool is operated continuously at low speeds, the motor will get overloaded and heated up. â· The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. The tool speed can be infinitely adjusted between 4, 000 and 11, 000 orbits per minute by turning the speed adjusting dial, which is marked 1 to 5. Higher speed is obtained when the dial is turned in the direction of number 5, lower speed is obtained when it is turned in the direction of number 1. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]