User manual MAKITA BO4554

[. . . ] Note: Specifications may differ from country to country. Intended use The tool is intended for the sanding of large surface of wood, plastics and metal materials as well as painted surfaces. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. [. . . ] This tool has not been waterproofed, so do not use water on the workpiece surface. Ventilate your work area adequately when you perform sanding operations. Some material contains chemicals which may be toxic. Take caution to prevent working dust inhalation and skin contact. Always use the correct dust mask/respirator for the material and application you are working with. Grasping one corner of the sandpaper, peel it from the pad. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by a Makita Authorized or Factory Service Centers, always using Makita replacement parts. Note: If the sandpaper is in good condition, save it for further use. The use of the dust bag makes sanding operations clean and dust collection easy. To attach the dust bag, fit the bag's entry port onto the dust spout on the tool so that the hole in the entry port is just over the protrusion on the dust spout. For the best results, empty the dust bag when it becomes about half full, tapping it lightly to remove as much dust as possible. To install the paper dust bag, place the paper dust bag on the paper dust bag holder with its front side upward. Insert the front fixing cardboard of the paper dust bag into the groove of the paper dust bag holder. 8) Then press the upper part of the front fixing cardboard in arrow direction to hook it onto the claws. 9) Insert the notch of the paper dust bag into the guide of the paper dust bag holder. Then install the paper dust bag holder set on the tool. Turn the tool on and wait until it attains full speed. then gently place the tool on the workpiece surface. A finishing sander is generally used to remove only a small amount of material at a time. [. . . ] The noise level under working may exceed 85 dB (A). ­ The typical weighted root mean square acceleration value is not more than 8 m/s2. The typical A-weighted sound pressure level is 82 dB (A). The noise level under working may exceed 85 dB (A). [. . . ]