User manual MAKITA BO5040

[. . . ] GEA010-1 FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. general Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] 5) Open the grip base, and attach it to the sander in the area of the Makita logo. 6) After closing the grip base, firmly tighten on the front grip to the screw section of the grip base. 7) To remove, loosen and remove front grip, and then remove grip base. 20) CAUTION: • Never run the tool without the abrasive disc. Excessive pressure may decrease the sanding efficiency, damage the abrasive disc or shorten tool life. € Using the tool with the pad edge contacting the workpiece may damage the pad. Turn the tool on and wait until it attains full speed. Then gently place the tool on the workpiece surface. Keep the pad flush with the workpiece and apply slight pressure on the tool. CAUTION: • The sanding pad rotates clockwise during the loaded operation, but it may rotate counterclockwise during the no-load operation. installing or removing abrasive disc (Fig. 8) To install the abrasive disc, first remove all dirt or foreign matter from the pad. Then peel off the backing paper from the abrasive disc and attach the abrasive disc to the pad. Be careful to align the holes in the abrasive disc with those in the pad. CAUTION: • If you peel off the abrasive disc from the pad, its adhesion will become poor. Never attempt to stick it onto the pad for further use. [. . . ] ENH101-14 ENG901-1 OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. [. . . ]