User manual MAKITA BPJ180

[. . . ] 4 V • Due to our continuing program of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE013-1 BPJ180 Plate Joiner 20 mm 6, 500 351 mm 3. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] Size on stopper Biscuit size Depth of groove 0 0 8 mm 10 10 10 mm 20 20 12. 3 & 4) The angle guide height can be moved up and down to adjust the position of the blade in relation to the top of the workpiece. To adjust the angle guide height, loosen the lock lever down and rotate the knob until the pointer points to the desired scale graduation marked on the angle guide. Then tighten the lock lever up to secure the angle guide. The scale on the angle guide indicates the distance from the top of the workpiece to the center of the blade thickness. The angle guide is removable from the fence according to the need of your work. To remove the angle guide, loosen the lock lever and turn the knob clockwise until it comes out of the upper end of the fence. 5 & 6) NOTE: • Remove the angle guide according to the need of your work when using the tool with the angle of the fence adjusted to other than 0°. When you need to use the angle guide under the above condition, be sure to adjust the depth of groove to get a proper depth. 7 The angle of the fence can be adjusted between 0° and 90° (positive stops at 0°, 45° and 90°). To adjust the angle, loosen the lock lever and tilt the fence until the pointer points to the desired graduation on the angle scale. Then tighten the lock lever to secure the fence. When the fence is set at 90°, both the distance from the center of the blade thickness to the fence and the distance from the center of the blade thickness to the bottom of the base are 10 mm. 11) CAUTION: • When installing the plate joiner blade, mount the inner flange with the side marked “22” facing toward you. To remove the blade, loosen the clamp screw and open the blade cover. Push the shaft lock and loosen the lock nut using the lock nut wrench. To install the blade, first mount the inner flange. Securely tighten the lock nut using the lock nut wrench. Close the blade cover and tighten the clamp screw to secure the blade cover. CAUTION: • Use only Makita lock nut wrench provided to remove or install the blade. €¢ Always check the depth of groove after replacing the blade. 9) CAUTION: • Before installing the battery cartridge into the tool, always check to see that the slide switch actuates properly and returns to the “OFF” position when the rear of the slide switch is depressed. [. . . ] Adjust the angle guide height so that the blade is centered in the board thickness. Align the center mark on the base with the pencil line on the workpiece. Switch on the tool and gently push it forward to extend the blade into the workpiece. Gently return the tool to the original position after the adjusting screw reaches the stopper. [. . . ]