User manual MAKITA BPT351

[. . . ] Groove Hook Screw Hex wrench Material to be fastened Bolt (B) Bolt (A) SPECIFICATIONS Model Pin nail size Pin nail magazine capacity Dimensions (L x W x H) Net weight Rated voltage BPT350 0. 18 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Intended use ENE068-1 The tool is intended for pressing pin nails into construction materials such as timbers. [. . . ] If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. Safety system WARNING: • Make sure all safety systems are in working order before operation. 2) Test safety systems for possible faulty operation before pin-nailing as follows. Make sure that the tool is not loaded with pin nails before the test. Pull the sliding door of the magazine toward yourself. The tool accidentally operates if only the trigger is pulled although the lever is not pulled. The tool does not operate when the trigger is pulled with the lever pulled. In case of 3 and 4 above, the safety systems are faulty. Trigger and lever CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 4) The tool is provided with lever as a safety system in addition to the usual trigger. Charge the battery cartridge before completely discharged. 5 To fire pin-nails, first pull the lever and then pull the trigger. Adjusting the depth of pin-nailing WARNING: • Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before loading the pin nailer. 6) Depth of pin-nailing can be adjusted on this pin nailer. [. . . ] To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. ASSEMBLY CAUTION: • Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before carrying out any work on the pin nailer. Loading the pin nailer CAUTION: • Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before loading the pin nailer. [. . . ]