User manual MAKITA BSS610RFE

[. . . ] Red part Button Battery cartridge Lever Stopper Base Cutting line Switch trigger Lock-off lever Shaft lock 11. Front grip Clamping screw Rip fence (Guide rule) Adjusting screw for 45° Adjusting screw for 90° Triangular rule Limit mark Brush holder cap Screwdriver Cutting depth No load speed (min-1) Overall length Net weight Rated voltage at 45° at 50° BSS610 165 mm 57 mm 40 mm 36 mm 3, 700 347 mm 3. Due to our continuing program of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. [. . . ] Lower guard should be retracted manually only for special cuts such as "plunge cuts" and "compound cuts. " Raise lower guard by retracting handle and as soon as blade enters the material, the lower guard must be released. For all other sawing, the lower guard should operate automatically. To avoid kickback, do support board or panel near the cut. Do not support board or panel away from the cut. Always observe that the lower guard is covering the blade before placing saw down on bench or floor. An unprotected, coasting blade will cause the saw to walk backwards, cutting whatever is in its path. Be aware of the time it takes for the blade to stop after Before setting the tool down after completing a cut, be sure that the lower guard has closed and the blade has come to a complete stop. Use extra caution when cutting damp wood, pressure treated lumber, or wood containing knots. Adjust speed of cut to maintain smooth advancement of tool without decrease in blade speed. Inspect for and remove all nails from lumber before cutting. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. 5 illustrates the RIGHT way to cut off the end of a board, and Fig. If the workpiece is short or small, clamp it down. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Do not stop the blades by lateral pressure on the saw blade. Always use blades recommended in this manual. Wear a dust mask and hearing protection when use the tool. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. [. . . ] ⷠNEVER tape down or defeat purpose and function of lock-off lever. When not in use, store the hex wrench as shown in the figure to keep it from being lost. When you wish to perform clean cutting operation, connect a Makita vacuum cleaner to your tool. Always insert the battery cartridge all the way until it locks in place. [. . . ]