User manual MAKITA BTD042

[. . . ] If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). [. . . ] Always check the direction of rotation before operation. ⷠUse the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. ⷠWhen not operating the tool, always set the reversing switch lever to the neutral position. this tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 6) The tool stops automatically after the battery capacity reaches under 20% to prevent the lack of fastening torque. ) Charge the battery or use a new fully charged one. Auto-stop setting for number of impacts This tool has a convenient auto-stop mechanism that allows you to preset the desired number of impacts in terms of the application. The tool then stops automatically after reaching the preset number of impacts. Keep on pulling the trigger after inserting the battery cartridge. (The indicating lamp on the back of the tool will flash about 10 times, then the lamp will keep lighting up lit. Hit the tool housing around the grip once with a screwdriver etc. Hit the tool housing preset number of first digit except 0. (The indicating lamp will light up in green color. Hit the tool housing preset number of second digit except 0. (The indicating lamp will light up in red color. ) Example: When the preset number is 12, hit the tool housing two times. Pull the trigger, then release the trigger. ) CAUTION: When you change the presetting, do the same procedure as above 1 ­ 8. To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. [. . . ] ⷠEven though the diameters of bolts are the same, the proper fastening torque will differ according to The manner of holding the tool or the material of driving position to be fastened will affect the torque. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. 14 & 15) Replace carbon brushes when they are worn down to the limit mark. Both identical carbon brushes should be replaced at the same time. [. . . ]