User manual MAKITA BTD129

[. . . ] If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. [. . . ] €¢ Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly. 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out just after the switch trigger is released. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. €¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. €¢ When not operating the tool, always set the reversing switch lever to the neutral position. 5 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. installing or removing driver bit or socket bit (Fig. 6) Use only bits that has inserting portion shown in the figure. NOTE: • Use the proper bit for the head of the screw/bolt that you wish to use. €¢ When fastening M8 or smaller screw, choose a proper impact force and carefully adjust pressure on the switch trigger so that the screw is not damaged. €¢ Hold the tool pointed straight at the screw. Before starting your job, always perform a test operation to determine the proper fastening time for your screw. The fastening torque is affected by a wide variety of factors including the following. After fastening, always check the torque with a torque wrench. [. . . ] €¢ • • • • • • • • Screw bits Hook Socket bits Plastic carrying case Makita genuine battery and charger Bit-piece Battery protector Drill bits with 1/4" Drill chuck assembly ENH101-15 For European countries only EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Impact Driver Model No. / Type: BTD129 are of series production and Conforms to the following European Directives: 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd. 2011 NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. [. . . ]