User manual MAKITA BTD134

[. . . ] 0 17 (S) 17 (S) 006255 006257 12 13 3 20 19 21 14 22 006258 15 012018 25 23 24 012019 16 17 27 012020 26 25 19 25 006304 18 4 012064 ENGLISH (Original instructions) Explanation of general view 1 2 3 4 5 6 7 8 9 Red indicator Button Battery cartridge Star mark Switch trigger Lamp Reversing switch lever LED indicator Bit 10 11 12 13 14 15 16 17 18 Sleeve Bit-piece Hook Screw Standard bolt Fastening torque Proper fastening torque Fastening time High tensile bolt 19 20 21 22 23 24 25 26 27 Limit mark Screws Rear cover Spring Arm Recessed part Carbon brush cap Lead wire Hole SPECIFICATIONS Model Machine screw Capacities Standard bolt High tensile bolt No load speed (min–1) 0 – 2, 400 0 – 3, 200 138 mm 1. 18 V BTD134 4 mm – 8 mm 5 mm – 14 mm 5 mm – 12 mm 0 – 2, 300 BTD146 Impacts per minute Overall length Net weight Rated voltage • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE033-1 SAVE THESE INSTRUCTIONS. [. . . ] Always insert it all the way until it locks in place with a little click. installing or removing battery cartridge (Fig. Install it fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when installing the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. €¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. €¢ When not operating the tool, always set the reversing switch lever to the neutral position. 6 Empty signal for remaining battery capacity (Fig. 6) Stop the tool and with the tool stopped press the button on the switch panel and the remaining battery capacity will be signaled on the panel. The status displayed on the switch panel and the remaining battery capacity is shown in the following table. LED indicator status Remaining battery capacity About 50% or more About 20% - 50% About less than 20% NOTE: • Before checking the remaining battery capacity, be sure to stop the tool. 10) The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. OPERATION The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The relation between fastening torque and fastening time is shown in the figures. 11, 12 & 13) Hold the tool firmly and place the point of the driver bit in the screw head. [. . . ] NOTE: • For all countries other than Europe, it's not necessary to pull the sleeve when installing the bit. €¢ If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. €¢ When it is difficult to insert the bit, pull the sleeve and insert it into the sleeve as far as it will go. [. . . ]