User manual MAKITA BTL062

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Capacities Square drive No load speed (RPM) Impacts per minute Max. fastening torque Overall length Net weight Rated voltage Standard battery cartridge · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] Keep handles dry, clean and free from oil and grease. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to impact wrench safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Check the socket carefully for wear, cracks or damage before installation. Be sure no one is below when using the tool in high locations. The proper fastening torque may differ depending upon the kind or size of the bolt. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Always stop tool operation and charge the battery cartridge when you notice less tool power. Volts direct current no load speed revolutions or reciprocation per minute number of blow Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. [. . . ] Adjust the angle head to the desired position and reinstall it so that the teeth on the housing will match up with the grooves in the angle head. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. [. . . ]