User manual MAKITA BTW201

[. . . ] 24 V • Due to our continuing program of research and development, the specifications herein are subject to change without notice. €¢ Note: Specifications may differ from country to country. Safety Hints For your own safety, please refer to the enclosed safety instructions. Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required. [. . . ] Sound of cooling air comes out during cooling, which means no trouble on the charger. €¢ Yellow light will flash for warning in the following cases. €“ Trouble on cooling fan – Incomplete cool down of battery, such as, being clogged with dust The battery can be charged in spite of the yellow warning light. But the charging time will be longer than usual in this case. Check the sound of cooling fan, vent on the charger and battery, which can be sometime clogged with dust. €¢ The cooling system is in order although no sound of cooling fan comes out, if the yellow warning light will not flash. €¢ The products should be sent to repair or maintenance, if the yellow warning light will frequently flash. Conditioning charge Conditioning charge can extend the life of battery by automatically searching the optimum charging condition for the batteries in every situation. The battery employed in the following conditions repeatedly, will be worn out shortly, and yellow warning light may flash. Recharge of battery with its low temperature 3. Trickle charge (Maintenance charge) If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its “trickle charge (maintenance charge)” mode and keep the battery cartridge fresh and fully charged. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge with room temperature at 10°C – 40°C (50°F – 104°F). let a hot battery cartridge cool down before charging it. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times. nOTE: • The battery charger is for charging Makita-battery cartridge. Charging will begin after the battery cartridge is cooled by the cooling fan installed in the charger. When the temperature on battery is more than approx. 70°C, two charging lights may flash in red color, and when approx. [. . . ] ) Note: Do not force the dial when turning. 7) Bolt fastening Dial setting Clockwise Tool stops after the twice the set number of impacts is reached. See the next section for the appropriate fastening torque. Counterclockwise Application Bolt fastening while controlling the number of impacts. [. . . ]