User manual MAKITA BUH650

[. . . ] Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage · Specifications and battery cartridge may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Noise The typical A-weighted noise level determined according to EN60745: Model BUH550 Sound pressure level (LpA) : 85. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ] Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The handle can be rotated to either 90° left or right and mounted either 45°or 90°position to fit your work needs. First, pull the knob and rotate the handle clockwise or counterclockwise in the direction of arrow as shown in the figure. CAUTION: Always make sure that the handle is locked in the desired position before operation. The battery cartridge is equipped with the protection system, which automatically cuts off the output power for its long service life. The tool may stop during operation when the tool and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the tool trouble. When the tool is overloaded: At this time, release the switch trigger and remove causes of overload and then pull the switch trigger again to restart. When the tool does not work even after pulling the switch trigger, the battery power auto-stop is still at work. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 2 For your safety, this tool is equipped with a dual switching system. to turn on the tool , press triggers A and B. Release either one of the two pressed triggers to turn off. The sequence of switching is unimportant as the tool only starts when both switches are activated. 3 The strokes per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. the dial is marked 1 (lowest speed) to 6 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the strokes per minute. CAUTION: The speed adjusting dial can be turned only as far as 6 and back to 1. [. . . ] 23 Place the new shear blades on the tool so that the oval holes in the shear blades fit onto the crank. Overlap the holes in the shear blades with the screw holes in the tool and then secure them with two screws. There is no distinction between the top and bottom of the plate. Remove the blade cover and then turn on the tool to check it for proper movement. [. . . ]