User manual MAKITA CL102D

[. . . ] Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Read this instruction manual and the charger instruction manual carefully before use. [. . . ] ⷠWhen the remaining battery capacity gets much lower, the tool stops during operation and the battery power lamp lights up for about ten seconds. At this time, remove the battery cartridge from the tool and charge it. nOTE: · The time at which the battery power lamp start blinking or lighting up depends on the temperature at work place and the battery cartridge conditions. Always stop tool operation and charge the battery cartridge when you notice less tool power. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Empty the cleaner before it becomes too full, or the suction force weakens. ⷠBe sure to empty out the dust inside the cleaner itself. Never throw away the dust stopper because it should be used whenever either the dust bag or the dust pack is used. Push the button to open the front cover. Opening it until a click is heard allows a positive stop at that position. nOTE: · The cleaner is constructed in such a way that the front cover comes off when trying to force the front cover open at the angle of more than 90°. If the front cover comes off, insert it into the front cover joint in place. cAUTION: · When closing the front cover, be careful not to pinch your fingers. Pull out both the orange-colored dust stopper and dust bag together at the same time. Use the dust stopper also when installing dust pack. Be careful not to take the upper side for the lower side by mistake because they are different each other. There is no distinction between the upper and lower sides of the dust pack. You may insert its protrusion of any side into the lower groove of the dust stopper. Place the dust stopper and the dust pack together into the cleaner cavity in the same direction of arrow on the dust stopper. Insert them all the way into the slots in the cleaner cavity. Place the entire container part of the dust pack inside the tool itself. cAUTION: · Forgetting to install the dust bag or the dust pack, failure to insert the dust stopper together with the dust bag or the dust pack all the way into the slots or using a broken or ripped bag, may allow dust to get into the motor. [. . . ] If washed in water, dry it up before installing. An insufficiently dried sponge filter may shorten the service life of the motor. Weak suction power · Empty dust bag or paper pack. ⷠDust down or wash the dust bag. [. . . ]