User manual MAKITA DA3000V

[. . . ] 1 2 3 4 Tighten Chuck key Switch lever (Paddle switch) Speed control screw Due to the continuing program of research and development, the specifications herein are subject to change without prior notice. Note: Specifications may differ from country to country. Power supply The machine should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. [. . . ] A speed control screw is provided so that maximum machine speed can be limited (variable). Machine speed is increased by increasing pressure on the lever. A speed control lever is provided so that maximum machine speed can be limited (variable). Be sure no one is below when using the machine in high locations. When drilling into walls, floors or wherever ``live'' electrical wires may be encountered, DO NOT TOUCH ANY METAL PARTS OF THE MACHINE!Hold the machine by the insulated grasping surfaces to prevent electric shock if you drill into a ``live'' wire. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. The switch lever (paddle switch) cannot be squeezed with the reversing switch knob positioned halfway between marking and marking. Always check the direction of rotation before drilling. You cannot obtain reversing switch action with the switch lever squeezed since the reversing switch knob is thereby locked. Turn the reversing switch knob so that its protrusion will point to marking for clockwise rotation or marking for counterclockwise rotation. CAUTION: Always be sure that the machine is switched off and unplugged before carrying out any work on the machine. Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. place the point of the bit in the indentation and start drilling. [. . . ] Both identical carbon brushes should be replaced at the same time. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by Makita Authorized Service Center. För medurs rotation (normalläge) vrids omkopplaren till markerinoch till för moturs rotation. [. . . ]