User manual MAKITA DBC250

[. . . ] Please read this booklet thoroughly to ensure you gain the best possible performance and outstanding results that your MAKITA Brush Cutter/String Trimmer can provide. You need to note the following symbols when reading the instructions manual. Wear eye and ear protection (for String Trimmer only) Take Particular care and Attention Wear protective helmet, eye and ear protection (for Brush Cutter only) Hot surfaces - Burns to fingers or hands Keep the area of operation clear of all persons and animals Wear sturdy boots with nonslip soles. ­ To ensure correct operation, make sure that you read and fully understand this instruction manual to familiarise yourself with how to use the Brush Cutter/ String Trimmer. [. . . ] Do not perform any modifications on the Brush Cutter/String Trimmer, as doing so will endanger your safety. The performance of maintenance or repair work by the user is limited to those activities described in the instruction manual. All other work is to be done by an Authorized Service Agent. Use only genuine spare parts and accessories released and supplied by MAKITA. Using non-approved accessories and tools will cause an increased risk of accidents. MAKITA will not accept any liability for accidents or damage caused by the use of non-approved cutting tools, fixing devices of cutting tools, or accessories. In case of accident, make sure that a first-aid box is available in the vicinity of the cutting operations. Immediately replace any item taken from the first aid box. When asking for help, please give the following information: Cardboard is a basic raw material and is therefore reusable or suitable for recycling (waste paper recycling). Model; DBC260U, DBC250 We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, ISO11806, EN55012 in accordance with Council Directives, 89/392/EEC, amended 98/37/EEC, 93/68/EEC, 89/336/EEC, amended 92/31/EEC. 7 dB Guarantee Sound Power: 114 dB These sound power levels were measured in accordance with Council Directive, 2000/14/EC. ­ Insert the Allen key through the hole in the gear case and rotate the receiver washer (3) until it is locked with the Allen key. With the Allen key still in place [Tightening torque: 13 - 23 N-m] NOTE: Always wear gloves when handling the cutter blade. nOTE: The cutter blade-fastening nut (with spring washer) is a consumable part. If there appears any wear or deformation on the spring washer, replace the nut. Doing so will only result in a higher production of combustion residues which pollute the environment and clog the exhaust channel in the cylinder as well as the muffler. ­ Thoroughly clean the area around the fuel filler cap (2) to prevent dirt from getting into the fuel tank (1). ­ Unscrew the fuel filler cap (2) and fill the tank with fuel. ⭠Tightly screw on the fuel filler cap (2). ­ Clean the screw fuel filler cap (2) and tank after refueling. Storage of Fuel Fuel cannot be stored for an unlimited period of time. ­ Adjust the strap length so that the cutter blade is kept parallel with the ground. [. . . ] ⭠Remove the air cleaner cover (3). ­ Remove the sponge element (2), wash it in lukewarm water and dry it completely. ­ After cleaning, put back the air cleaner cover (3) and fasten it with screw (1). NOTE: If there is excessive dust or dirt adhering to the air cleaner, clean it every day. [. . . ]