User manual MAKITA DF010D ANNEXE 315

[. . . ] Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. [. . . ] If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. When the lock button is in the locked position B, the switch cannot be actuated. When the lock button is in the unlocked position A, the switch can be actuated. Before inserting the battery cartridge into the tool, always check to see that the switch actuates properly and returns to the "OFF" position when released. To start the tool, first move the lock button to the unlocked position A to release the switch. And then simply push the switch on the C side for the clockwise rotation and the 5 Guideline for clutch auto-stop Work range of Increments on clutch auto-stop adjusting ring for fastening High Low torque speed speed 1 Clutch autostop works 5 9 13 17 21 Do not use any other driver bit or socket bit. For other countries A=17 mm B=14 mm A=12 mm B=9 mm To install these types of bits, follow the procedure (1). To install these types of bits, follow the procedure (2). To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. To install the bit, pull the sleeve in the direction of the arrow and insert the bit-piece and bit into the sleeve as far as it will go. The bit-piece should be inserted into the sleeve with its pointed end facing in. 10) To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. nOTE: · If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. Do not look in the light or see the source of light directly. To turn on the light, slide the lamp switch to the A position. To turn off the light, slide the lamp switch to the B position. Even if you leave the lamp on, the light will automatically turn off after 5 minutes. [. . . ] These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. [. . . ]