User manual MAKITA DPC7301

[. . . ] For the components listed under PARTS COVERED, the service dealer authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ] Before performing maintenance work switch off the Power Cut (27) and pull out the plug cap. Always check the Power Cut before using it to make sure that it is in good working order. in particular , make sure that the cutting disc is properly mounted. Make sure that the cutting wheel is undamaged and suitable for the job it will be used for. Operate the Power Cut only at a low noise and emission level. You will only be putting your own safety at risk!Perform only the maintenance and repair works described in the instruction manual. All other work must be carried out by MAKITA Service. use only original MAKITA spares and accessories. The use of non-MAKITA spares, accessories, or cutting discs increases the risk of accident. We cannot accept any responsibility for accidents or damage occurring in association with the use of cutting discs or accessories other than original MAKITA. IMPORTANT: After tightening/inspection, make certain to tighten the fastening nuts (11) (30 ± 2 Nm). CAUTION: Before doing any work on the Power Cut, always switch off the engine and disconnect the spark plug cap!NOTE: When using a protective hood for a maximum disk diameter of 300 mm (12"), always shorten hose (1) to 180 mm (7"). To do this unscrew sleeve (2) and carefully pull tube (1) off coupling (3) and cut to 180 mm. Then push the tube end back over the coupling and tighten the sleeve all the way. install the water connection as shown in Figure H. Push clamp (H/8) around the front grip (H/9) and fasten with the bolt and square nut. Pull the quick-release coupling (H/10) from the water connection and connect it to the 1/2" supply line (4). remove the cutting disk (see instruction manual). Tube routing with the cutting assembly in the middle position, see Fig. Tube routing with the cutting assembly in the outside position, see Fig. [. . . ] In case of damage, have repaired by a qualified service center immediately Remove and clean Empty and clean Run empty 13 17 7 14 7 The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a workshop equipped with special tools and testing devices. We therefore recommend that you consult a MAKITA service center for all work not described in this instruction manual. The MAKITA service centers have all the necessary equipment and skilled and experienced personnel, who can work out costeffective solutions and advise you in all matters. Please contact your nearest service center (list enclosed) or the general trading company or importer (see last page), who will gladly provide you with the address of your nearest MAKITA service center. [. . . ]