User manual MAKITA DPC8111

[. . . ] Always follow safety precautions in the Instruction and Safety Manual. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. A, Inc warrant to the initial retail purchaser and each subsequent owner, that this utility equipment was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. [. . . ] NOTE: The two fastening nuts (11) must be loosened before tightening the V-belt or checking the tension. To increase the belt tension, turn the tightening screw (12) to the right (clockwise) with the combination wrench included with the Power Cut. The belt tension is correctly adjusted when the nut (13) is centred on the mark (14). IMPORTANT: After tightening/inspection, make certain to tighten the fastening nuts (11) (30 ± 2 Nm). Installing the pressure water system Not in the general scope of delivery. CAUTION: Before doing any work on the Power Cut, always switch off the engine and disconnect the spark plug cap!NOTE: When using a protective hood for a maximum disk diameter of 300 mm (12"), always shorten hose (15) to 180 mm (7"). 15 16 21 17 19 20 17 21 To do this unscrew sleeve (16) and carefully pull tube (15) off coupling (17) and cut to 180 mm. Then push the tube end back over the coupling and tighten the sleeve all the way. - Install the water connection as shown in figure. Push clamp (22) around the front grip (23) and fasten with the bolt and square nut. - Tube routing with the cutting assembly in the middle position, see figure. - Tube routing with the cutting assembly in the outside position, see figure. - Remove the cutting disk (see instruction manual). - Pull the quick-release coupling (24) from the water connection and connect it to the 1/2" supply line (18). - Insert the nozzles (19) through the protective hood (20) from the inside and put on couplings (17). Screw on and tighten the coupling caps (21). IMPORTANT: To avoid bending the tubes, be sure to position the couplings (17) in accordance with figures as appropriate. - Install the cutting disc (see instruction manual). NOTE: - Connect the quick-release coupling (24) to the supply tube. The water flow rate can be precisely adjusted with valve (25). 15 18 * 23 22 25 24 Fuels Caution: The Power Cut uses mineral-oil products (gasoline and oil). [. . . ] Please note that we cannot accept any responsibility for damage caused by: • • • • • • • • • • • • • Disregard of the instruction manual. The use of other than original MAKITA cutting discs. Use of force, improper use, misuse or accidents. Damage from overheating due to dirt on the fan housing. [. . . ]