User manual MAKITA G41OOR

[. . . ] The period of time (in hours) that the Air Index level is measured is known as the durability period. Depending on the size of the engine, a selection of time periods can be used to measure the Air Index level (see below). Descriptive Term Moderate Intermediate Extended Applicable to Emissions Durability Period 50 hours (engine from 0 to 80 cc) 125 hours (engine greater than 80 cc) 125 hours (engine from 0 to 80 cc) 250 hours (engine greater than 80 cc) 300 hours (engine from 0 to 80 cc) 500 hours (engine greater than 80 cc) Notice : This hangtag must remain on this engine or piece of equipment, and only be removed by the ultimate purchaser before operation. FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applicable in all States, except the State of California Makita U. S. A. Inc. , La Mirada, California, (herein "MAKITA") warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein "engine") has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. S. [. . . ] Wipe off spilt fuel thoroughly before starting engine. 7 CHECKING COMPONENT PARTS Check following items before starting engine: Fuel leakage from fuel hose, etc. Generator not resting on or against any adjacent wiring. CHECK GENERATOR SURROUNDINGS. WARNING Make sure you review each warning in order to prevent fire hazard. Keep area clear of in flammables or other hazardous materials. Keep generator at least 3 feet (1 meter) away from buildings or other structures. Only operate generator in a dry, well ventilated area. Keep exhaust pipe clear of foreign objects. Keep generator on a stable and level surface. Do not block generator air vents with paper or other material. 8 BATTERY INSTALLTION (Electric starter model) Recommended Battery: A capacity of 12V-24AH or larger. WARNING Death, personal injury and/or property damage may occur unless instructions are followed carefully. Turn the starter switch to the "STOP" position when mounting or dismounting battery. When mounting battery, connect the positive (+) cable first and then the negative (-) cable to the battery. Failure to ground unit may lead to electrical shock. CONTROL PANEL (G2800R) 9 11 1 ENGINE SWITCH ON PILOT LAMP AC BREAKER ON OFF 4 OFF AC 120V 2 AC MAX 19. 2A ON DC Battery charge only DC 12V - 8. 3A DC BREAKER GROUND OFF RESET TEST 5 7 3 7 DC circuit breaker 8 Idle control switch 9 Engine switch !0 Key switch !1 Pilot lamp 1 No-fuse breaker 2 AC receptacle 3 Earth (Ground) teminal 4 Voltmeter 5 DC output terminal 6 Full power switch 13 (G4101R / G41OOR) 8 6 4 11 1 10 FULL POWER SWITCH 120V 120V/240V PILOT LAMP AC BREAKER ON START SWITCH ENGINE SWITCH ON 9 IDLE CONTROL 7 ON DC BREAKER OFF ON OFF OFF OFF G41OOR 30A 125V Battery charge only 20A 125V TEST RESET 20A AC MAX 30A AC MAX 20A AC MAX 20A AC 120V AC MAX 20A DC 12V - 8. 3A AC 120V / 240V 5 GROUND 3 2 (G6101R / G6100R) 8 6 4 11 1 10 FULL POWER SWITCH 120V 120V/240V PILOT LAMP AC BREAKER ON START SWITCH ENGINE SWITCH ON 9 IDLE CONTROL 7 ON DC BREAKER OFF ON OFF OFF OFF G6100R 30A 125V Battery charge only 20A 125V TEST RESET 20A AC MAX 30A AC MAX 20A AC MAX 20A AC 120V AC MAX 20A DC 12V - 8. 3A AC 120V / 240V 5 GROUND 3 2 14 (1) AC APPLICATION (a) Check the pilot lamp for proper voltage. This generator is thoroughly tested and adjusted in the factory. If the generator does not produce the specified voltage, consult your nearest Makita factory or authorized service center. (b) Turn off the switch (es) of the electrical appliance (s) before connecting to the generator. PILOT LAMP (c) Insert the plug (s) of the electrical appliance(s) into the receptacle. Check the amperage of the receptacles used referring to TABLE 1, and be sure not to take a current exceeding the specified amperage. Be sure that the total wattage of all appliances dose not exceed the rated output of the generator. (d) Turn the no-fuse breaker to the position "ON". ON OFF 15 Style Ampere up to 20A Receptacle NEMA 5-20R NEMA L14-20R NEMA L5-30R NEMA L5-20R TABLE 1 AC plug NEMA 5-20P NEMA L14-20P NEMA L5-30P NEMA L5-20P Description GFCI (Ground Fault Circuit Interrupter) Receptacle, duplex (REC 1) Locking Receptacle (REC 4) up to 20A up to 30A Locking Receptacle (REC 2) Locking Receptacle (REC 3) up to 20A WARNING To take power out from the TWIST LOCK RECEPTACLE, insert the plug into the receptacle, and turn it clockwise to the lock position. Be sure to ground the generator if the connected electrical device Is grounded. NOTE : When the no-fuse breaker turns off during operation, the generator is over loaded or the appliance is defective. Stop the generator immediately, check the appliance and / or generator for overloading or detect and have repaired as necessary by Makita factory or authorized service center. TWIST CAUTION The duplex 120V receptacle is protected by a GFCI (Ground Fault Circuit Interrupter). GFCI shuts off the output current from the duplex 120V receptacle when a ground fault occurs in the generator or the appliance. Please note that other receptacles are not protected by GFCI. [. . . ] (b) Clean the screen and strainer cup with gasoline. (c) Tightly fasten the cup to main body, making sure to avoid fuel leak. FUEL HOSE REPLACEMENT WARNING Take extreme caution when replacing fuel hose ; gasoline is flammable. Replace the fuel hose every 1, 000 hours or every year. If fuel hose leak is found, replace the fuel hose immediately. 30 10. [. . . ]