User manual MAKITA GA7031Y

[. . . ] Model Wheel diameter Spindle thread No load speed (RPM) Overall length Net weight · Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] Use only flanges specified for this tool. Be careful not to damage the spindle, the flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage. NEVER use tool with wood cutting blades or other sawblades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury. Do not wrap cord around your arm or wrist. If control of tool is lost, cord may become wrapped around you and cause personal injury. Make sure the wheel is not contacting the workpiece before the switch is turned on. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel. use the specified surface of the wheel to perform the grinding. Hold the tool so that sparks fly away from you and other persons or flammable materials. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. ALWAYS wear proper apparel including long sleeve shirts, leather gloves and shop aprons to protect skin from contact with hot grindings. Use of this tool to grind or sand some products, paints and wood could expose user to dust containing hazardous substances. use appropriate respiratory protection. After using the tool, make sure the wheel rotation comes to a complete stop before setting the tool down. Setting the tool down with the wheel rotating can cause personal injury. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Press the shaft lock to prevent spindle rotation when installing or removing accessories. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. For continuous operation, pull the switch trigger and then push in the lock button, and then relese the switch trigger. [. . . ] Use of damaged brush could increase potential for injury from contact with broken brush wires. Unplug tool and place it upside down allowing easy access to spindle. Mount urethane washer then thread wire cup brush onto spindle and tighten with supplied wrench. When using brush, avoid applying too much pressure which causes over bending of wires, leading to premature breakage. [. . . ]