User manual MAKITA GN900

[. . . ] Model Nail length X Shank diameter Nail capacity Nail collation angle (degree) Figure of nail head Dimensions (L X H X W) Net weight Rated voltage Standard battery cartridges · Specifications and battery cartridge may differ from country to country. Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Read and understand tool labels and manual. Operators and others in work area must wear safety glasses with side shields. [. . . ] The safety glasses should conform with the requirements of ANSI Z87. WARNING: It is an employer's responsibility to enforce the use of safety eye protection equipment by the tool operators and by other persons in the immediate working area. Wear hearing protection to protect your ears against exhaust noise and head protection. Do not operate when under the influence of alcohol, drugs or the like. general Tool Handling Guidelines: (1) Always assume that the tool contains fasteners. (2) Do not point the tool toward yourself or anyone whether it contains fasteners or not. (3) Do not actuate the tool unless the tool is placed firmly against the workpiece. (6) Do not hold or carry the tool with a finger on the trigger. (7) Do not load the tool with fasteners when any one of the operating controls is activated. (8) Do not operate the tool with any power source other than that specified in the tool 4 Sparks sometimes fly when the tool is used. Do not use the tool near volatile, flammable materials such as gasoline, thinner, paint, gas, adhesives, etc. ; they will ignite and explode, causing serious injury. The area should be sufficiently illuminated to assure safe operations. The area should be clear and litter-free. Be especially careful to maintain good footing and balance. Only those involved in the work should be in the vicinity. Children especially must be kept away at all times. There may be local regulations concerning noise which must be complied with by keeping noise levels within prescribed limits. In certain cases, shutters should be used to contain noise. Do not play with the contact element: it prevents accidental discharge, so it must be kept on and not removed. Do not operate a tool if any portion of the tool operating controls is inoperable, disconnected, altered, or not working properly. Always check the tool for its overall condition and loose screws before operation. [. . . ] When you get home: (1) Place the battery cartridge in its charger if it needs charging as indicated by the red indication lamp near the handle. (2) Wipe your Cordless Clip Head Framing Nailer with a clean, soft cloth. (3) Check the filter and clean if it is dusty. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. [. . . ]